-
'Mining Lasers' - Set the number of
mining lasers you have on your ship. EVEPilot will look for
the mining lasers in slots: high-1, then high-2 then high-3. This
setting is a quick alternative to module fittings panel.
-
'Asteroids to Mine' - This is
the maximum number of asteroids you want to target and mine. If you use combat
drones, then one target slot is reserved for the fight module. You
should get targeting trained to at least level 3.
-
'Blind Miner' is an option that will
skip control of a client to increase the overall speed when running
multiclients. There are a few periods when control of the client is not
required:
-
For about 7 seconds after
dock or undock.
-
For about 40 seconds after
warp has been initiated.
-
A period of time after mining
laser activation.
-
Blind miner has some disadvantages
and should only be enabled if you are using multiclient or if you want to add
constant checks of NPCs or PCs during mining. If your ship is
destroyed in a belt by players or NPC, you will temporarily fly
around in a pod because EVEPilot wont expect this. This might
not be so bad as a human afk miner will not log off
straight away after getting suicide ganked. To add constant checks
for NPC/PC also activate 'Avoid PC/NPC' checkboxes.
-
'Max Targets' - Set the number
of things you can target. As a general rule, this number is equal to
your targeting skill + 2.
-
'Max Time While In Belt' - This
timeout will warp your ship to station. The time starts counting from the
moment you warp to the belt.
-
If the client spends less then 75%
of 'Max Time While In Belt' before it fills the cargohold (to 100%),
EVEPilot will warp to the same belt next time. Set max time in
belt to real value and bot will select good belts and move out from
bad!
-
You can calculate the number
of seconds you need to enter by noting the time it takes to fill
cargohold and then add 25%.
-
You can use it when:
-
You ice mine. It is
better to limit the amount of time mining by using a
timeout rather then by cargohold capacity.
-
If you want to warp to a new belt every
time that EVEPilot has to select the destination
belt to warp to.
-
'Mark Belt As Non Profitable' - If the
takes longer to fill the cargohold than the figure entered into 'Max Time
While In Belt', you can choose to mark the belt as non profitable.
EVEPilot will not warp here until it is profitable to do so
again or there are no more belts in the system. Checking
this option is good idea when you have many bookmarks and there are
plenty of belts to mine from.
-
'Minimal cargo' - If
the cargohold has less than this figure EVEPilot will
only stop mining when it hits the 'Max Time While In Belt' timeout. The
cargohold load analysis and warp out time estimation functions will
be switched off.
-
'Maximal Cargo' - Set the
maximum cargohold percentage. When the cargohold reaches this figure it
will warp to station. Set minimal cargo = maximal cargo if you mine
ice.
-
'Max # of BMs' - Set the
maximum number of bookmarks you want to use for mining. During automatic
bookmark creation, this limit not applied. EVEPilot will automatically detect
that you have less bookmarks than this figure in a system.
-
'Ore Hold Present' checkbox must be checked
if you mine to ore hold. If you use mining frigate
you must tick this checkbox aswell. Untick this option is you want to start
deliverer. Deliverer does not use orehold.
-
'Use Corporation Office' - tick if you
want to unload ore to corp hangar and have corp office in
station/citadel
-
'Autocreate BMs' - EVEPilot must have bookmarks
in the system in order to function. This failsafe is checked by
default for new users. Once all the bookmarks have
been created please uncheck this option because
it might delete your bookmarks and recreate them under
certain conditions. This function will add maximum 14 bookmarks (the
number of lines visible in overview without scrolling). To have more bookmarks
place
them manually.
-
'Refit Crystals' - The option was used to
drag crystals from station when no ordeholds were introduced yet. If you
only mine one type of ore you can set EVEPilot refit
the crystals. T1 and T2 crystals supported. Does not work on POS. You may
save time on additional checks if you fill cargohold with crystals, load
crystals to lasers manually and disable this option.
-
'Use Survey Scanner' - If you have
a survey scanner you can scan the content of asteroids and detect the
amount of time before the asteroid is depleted so the mining
lasers can be switched off. Choose the position of survey scanner using
module
fittings panel.
-
Timeout to lock target - Timeout usually applies
when your ship jammed by NPC. This way bot will exit waiting procedure earlier
and do other actions.
-
Unload to Jettison Container - Set this flag and
bot will not return to station or POS to unload ore. It will jettison ore in
space or use existing jettison container. Default name of container is an UTC
time in HH:MM format. You should have your computer clock synchronized
to set this time correctly. Name expression may be used to customize
format of jetcont name. You can use any number or letter, space or a
few simbols as a static part of the name. Expressions in
brackets {HH}, {MM} and {NN} may be used to add changeable part
to the name, where {HH} is current hour, {MM} is current minute and {NN}
is a number in the range 1-99. Example: if expression is {NN} bot will name
containers as 1, 2, 3..., if C-{NN} new names will look like C-1, C-2, C-3
etc. Numeric part of the name defined by {NN} expression will
increment if container with corresponding name already
exists.
-
Dont Rename Jetcont - set this flag to leave
default jetcont name
-
If you want to repair your ship in station tick
'Use Repairshop' checkbox. Bot will repair all damaged items in this station
but start this procedure if armor damage detected last time when bot docked to
a station.