How do I setup the module fitting so HuntBot will turn on low slot hardeners?

Also, What do I set the web to?

Bump?

In the latest version I made an attempt to use webifier. There is a setting Neut/Web/Target Painter, use it to define position of a module. Bot will not check for optimal range, but will attempt to activate module after laser activation.

What is the problem with hardeners? Just set them as active modules, assign a rule 100-100 to activate all the time. This is in the manual. I did not change anything here from the miner.

Oh, I did not set a rule for the active hardeners... That is my fault! Thanks!