Welcome, Guest
Please Login or Register.    Lost Password?

Turn on hardeners and using web
(0 viewing) 
Go to bottomPage: 1
TOPIC: Turn on hardeners and using web
#30614
Turn on hardeners and using web 7 Years, 10 Months ago Karma: 0
How do I setup the module fitting so HuntBot will turn on low slot hardeners?

Also, What do I set the web to?
SokarNox
Junior Boarder
Posts: 55
graphgraph
User Offline Click here to see the profile of this user
The administrator has disabled public write access.
 
#30630
Re: Turn on hardeners and using web 7 Years, 10 Months ago Karma: 0
Bump?
SokarNox
Junior Boarder
Posts: 55
graphgraph
User Offline Click here to see the profile of this user
The administrator has disabled public write access.
 
#30644
Re: Turn on hardeners and using web 7 Years, 10 Months ago Karma: 757
In the latest version I made an attempt to use webifier. There is a setting Neut/Web/Target Painter, use it to define position of a module. Bot will not check for optimal range, but will attempt to activate module after laser activation.

What is the problem with hardeners? Just set them as active modules, assign a rule 100-100 to activate all the time. This is in the manual. I did not change anything here from the miner.
Slav2
Admin
Posts: 15802
graph
User Offline Click here to see the profile of this user
The administrator has disabled public write access.
Send logs to my mail - with subject 'log files' to pass spam filter.
How to record logs in knowledge base
 
#30648
Re: Turn on hardeners and using web 7 Years, 10 Months ago Karma: 0
Oh, I did not set a rule for the active hardeners... That is my fault! Thanks!
SokarNox
Junior Boarder
Posts: 55
graphgraph
User Offline Click here to see the profile of this user
The administrator has disabled public write access.
 
Go to topPage: 1
Moderators: Slav2
© Macro Laboratory 2021
All rights reserved!
Design by Ivan Kozyrin